ImageNest RIP and Canon Printers: The ImageNest RIP is compatible with all models of Canon printers that run on Mac OSX 10.4 or higher. Below are several different dialogs of ImageNest and the Canon Print Driver. Different models of Canon Printers have slightly different dialogs but the dialogs below should be consistent on all Canon models. If you have any questions please do not hesitate to contact us.
| When using the below method make sure that your have “ImageNest Manages Colors” Selected. |
 |
|
Canon Driver Preferences: Color Matching Select “Vendor Matching” as your Color Matching Method. This will turn off all ColorSync color management. ColorSync’s system will not apply an output profile since it has already been applied to your images in ImageNest. |
 |
|
Canon Driver Preferences: Main Media Type: The media type setting controls the internal Color look up table (Which will contain lineariation, ink limit and total ink limit) that the driver will use in conjunction with an ICC profile. If you are using a custom profile pick a Canon media that is as close as possible to the media you are using. Most third party medias will specify what media type setting was used when creating a custom profile. Advanced Settings: These settings can be set to whatever a users individual preferences are. They will not effect color. |
 |
|
Canon Driver Preferences: Page Setup Paper Source: The Paper Source setting should be set to Roll or Sheet according to a users needs. “Save Roll Paper” setting will optimize page length based on the total area of an image layout rather than the page size. If, for example, a page size on 24 inches by 100 inches is selected in ImageNest and a 24 inch by 10 inch image is printed, the 100 inch page length will automatically be re-sized to 10 inches in length. This enables users to use the same page size for a variety of different jobs without wasting paper. |
 |